Power TIG 1640 DC-HF

Power TIG 1640 DC-HF

 

The POWER TIG 1640 DC HF is a DC TIG/MMA welding power source, inverter technology. In TIG mode the arc is started either in HF
or with the Cebora lift system.

It features a 2 stage/4 stage selection key, while the remote control device allows to connect a foot control or, alternatively, to work with a torch fitted with an up/down control.

The welding current can be adjusted from 5 to 160A and two potentiometers allow respectively the slope down and the post-gas function adjustment.
This power source represents the entry level model in the complete range of Cebora DC TIG welding power sources and is mainly intended for maintenance and repair work, as well as for small productions.
The compliance with EN 61000-3-12 brings substantial energy saving and a wide supply voltage tolerance (+15% / -20%).

The power source can be powered by motor generators of adequate power (Min. 6 KVA).